Wooden Propeller Forum  

Go Back   Wooden Propeller Forum > Design and Manufacturing > Manufacturers

Reply
 
Thread Tools Display Modes
Old 12-04-2011, 06:41 PM   #1
KosPilot
 
KosPilot's Avatar
 
Join Date: Dec 2011
Location: Melbourne, Australia
Posts: 2
Send a message via Skype™ to KosPilot
Default Classic knowledge in new design

Hi all, I am new to this forum and hoping that I may pick your brains about the manufacturing techniques used for creating wooden airfoils.

As my profile suggest, I'm into renewable energy. I am now in the process of creating the blades for a VAWT (Vertical Axis Wind Turbine) in a helical configuration. Because of the complex shape of the blades, I will have to do everything from scratch, even laminating the oak myself. Gluing and shaping the oak laminate should not be too hard (I hope...), but time consuming.
The big questions are:
1. What glue would be the best one to use for the laminating process?
and
2. To protect the wood from exposure to the elements, what chemicals should be used to treat and seal the wood (from start to finish)?

I understand that this thread may be considered a bit off topic for this forum, but it would be such a privilege to put classic knowledge to good use in a modern design like this.
__________________
"Helicopter pilots get it up quicker" - Spud
KosPilot is offline   Reply With Quote
Old 01-30-2012, 09:43 AM   #2
drrivah
 
Join Date: Jan 2012
Posts: 31
Default Wind turbines

Try:

tortiecat9@aol.com

Her M.S. engineering degree involved vertical wind turbine design.

-peb
drrivah is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 11:42 AM.


Powered by vBulletin® Version 3.8.9 Beta 3
Copyright ©2000 - 2017, vBulletin Solutions, Inc.