Fudge Snow-sedan propeller - Page 2

craigger · 06-07-2015, 01:27 AM

THat would be great. I would like to speak with you about that. Do you use aircraft approved material or is it even required. I do have one blade but it is cracked but complete. Any idea of cost and lead time. Can you balance them?

Craigger

maxim08 · 06-17-2015, 09:31 AM

Craigger

Apologies for the delayed response, but I don't frequent here very often.

Materials would be as original, whatever that may be re wood species. I have used West Systems epoxy successfully for laminating. I have not made blades for a 3 bladed prop before, but would want each to be the same overall weight. A static balance with the hub would be necessary after assembly.

I just saw your PM and have sent one in return.

Regards
John

06-07-2015, 01:27 AM	#11
craigger Join Date: May 2015 Posts: 3	Manufactured Blades THat would be great. I would like to speak with you about that. Do you use aircraft approved material or is it even required. I do have one blade but it is cracked but complete. Any idea of cost and lead time. Can you balance them? Craigger

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

06-17-2015, 09:31 AM	#12
maxim08 Join Date: Aug 2009 Posts: 25	Craigger Apologies for the delayed response, but I don't frequent here very often. Materials would be as original, whatever that may be re wood species. I have used West Systems epoxy successfully for laminating. I have not made blades for a 3 bladed prop before, but would want each to be the same overall weight. A static balance with the hub would be necessary after assembly. I just saw your PM and have sent one in return. Regards John