View Single Post
Old 05-30-2014, 04:55 PM   #2
Dave
Moderator
 
Join Date: Jan 2006
Location: Vermont
Posts: 2,832
Default

Not much help, but I notice that it is a left hand thread, which is less common than right hand and sometimes (but not always) indicates a pusher application.

Even a "small discrepancy" in bolt circle diameter, center bore, or bolt hole size is probably enough to eliminate a specific engine. Hub thickness can vary a little bit due to normal expansion or shrinkage of wood with moisture, but the other measurements not so much.
__________________
Dave
Dave is offline   Reply With Quote