View Single Post
Old 03-09-2010, 12:32 PM   #3
gordy8
Guest
 
Posts: n/a
Default Dimensions of propeller

Hello Dave,

I believe I have done this correctly... The center bore is 2 and 5/8 (2.625)inches as best I can measure. The bolt diameter is 3/8 (.325) of an inch. The bolt hole diamter (center to center is 5 and 1/4 inches (5.25)) and the hub is 4 inches thick. Based on the charts on the web page, I believe your first thought was correct, and the propellor was made for a Curtiss OX5. I have attached a photo of the decal.

It pains me to have to sell the propeller but I have been unemployed for a while and need to sell a few of my things...

Thank you again for all your help. It is very much appreciated.

David
Attached Images
File Type: jpg decal 2.jpg (97.6 KB, 37 views)
  Reply With Quote