View Single Post
Old 08-29-2019, 12:25 PM   #6
Site Admin
Join Date: Nov 2008
Posts: 1,265

That's certainly a good possibility. I don't know enough about Anzani hubs to say, but the metal hub similarity is certainly suggestive of an Anzani engine. I measured the center bore of this propeller at just about 1 3/4 inches, which looks consistent with this one.

This propeller is for a 125 HP Anzani and obviously uses a different hub, with 8 bolt holes.

Hopefully PMdec will see this and offer an opinion. I get the feeling that it is an early and perhaps rare model.
Dbahnson is offline   Reply With Quote