View Single Post
Old 10-17-2017, 04:19 PM   #2
Site Admin
Join Date: Nov 2008
Posts: 747

It could be almost anything, and without numbers stamped on it the possibilities are wide ranging.

This ridge (see the attached photo) isn't normal, and suggests that the hub was cut out at some point then filled with a milled piece of wood overlapping the native surface.

I would review this page, measure the hub dimensions very carefully and see if you can eliminate most of the engines listed on the linked page.
Attached Images
File Type: jpg prop 4a.jpg (61.4 KB, 6 views)
Dbahnson is offline   Reply With Quote